AN-1601: Controlling SiC MOSFET Power Switches with SCALE-2 and SCALE-2+ Gate Drivers Cores and SCALE-iDriver Gate Driver ICs.
This application note discusses procedures to optimize use SCALE gate drivers with SiC MOSFET switches.
AN-1501: Handling Instructions for SCALE-1 and SCALE-2 Gate Drivers
This application note defines requirements for handling high-power SCALE-1 and SCALE-2 products (gate driver cores, plug-and-play gate drivers) from Power Integrations in terms of: storage conditions, soldering instructions, mechanical handling, ESD handling, and RMA guidelines.
AN-1001: IGBT and MOSFET Drivers Correctly Calculated
This application note describes the calculation of the gate drive performance figures required for a given application. The values as derived from this application note serve as a base for selecting the most appropriate driver.
AN-9901: Design of driver cards with SCALE drivers
Notes for implementing IGBT driver cards
You should read this application note if you wish to design driver cards with SCALE drivers…
AN-9902: Two and four-quadrant DC/DC converters with SCALE drivers
Notes for the use of dead-time logic
Special application of SCALE drivers...
AN-0801: Mechanical Handling of CONCEPT Drivers
This application note describes the correct mechanical handling of CONCEPT drivers. It particularly points out that no excessive mechanical force should be applied to transformers.
AN-0901: Methodology for Controlling Multi-Level Converter Topologies with SCALE-2 IGBT Drivers
This application note describes the methodology for controlling multi-level converter topologies with SCALE-2 IGBT drivers in case of a fault. Multi-level converters use series-connected IGBTs to increase both the amplitude and switching frequency of the converter output voltage.
AN-0902: Avoiding ESD with CONCEPT Drivers
This Application Note describes the minimum requirements for preventing ESD during handling and assembly of all CONCEPT gate driver devices. CONCEPT products are sensitive to electrostatic discharge (ESD), as are MOSFETs and IGBT modules.
AN-0904: Direct Paralleling of SCALE-2 Gate Driver Cores
Parallel-connected IGBTs are conventionally driven by a common driver, with individual gate and emitter resistors for each IGBT. An alternative approach to driving parallel-connected IGBT modules is to use an individual driver for each module.
AN-1101: Application with SCALE-2 Gate Driver Cores
This application note will highlight important design rules and help to speed up the development time by showing detailed examples about how to design successfully IGBT drivers for industrial and traction applications. Considered SCALE-2 driver cores are: 2SC0108T, 2SC0435T, 2SC0650P and 1SC2060P.
AN-1301: Do’s and Don’ts with SCALE™-2 Gate Drivers
This Application Note highlights important points that must be considered when using SCALE™-2 driver cores as well as plug-and-play drivers. It complements Application Note AN-1101 /1/.